Aquaproof & Anchoring Systems

Additional Information:-

• Anchor bolt for push-through and pre-positioned installation.
• When the hexagon nut is tightened, the tapered bolt is pulled into the expansion clip and expands it against the hole wall.
• A4 stainless steel and hot-dip galvanised version for outdoor use and in damp conditions.
• For wooden structures use the FBN II GS with large washer as per DIN 440.

Advantages/Benefits

• Long thread allows stand-off installations and variable usable lengths.
• FBN II 8 K to FBN II 20 K mm diameter also for reduced anchorage depths, e.g. for small loads or if reinforcements are hit.
• Embossed letter on the head for subsequent control of the installation as it indicates the setting depth.
• Hook anchor FBN 8 H for simple installation of meshed reinforcements, wire gratings, etc.

In the European Technical Assessment (ETA), which takes into consideration all classes of building materials, several anchorage depths are regulated: 50, 70 and 90 mm for SXRL 8 and SXRL 10, 70 and 90 mm for SXRL 14. ??? The SXRL 14 is additionally approved for applications that are subject to pressure and may be used for façade structures that are installed without wall brackets with a spacing

Additional Information

• Heavy-duty sleeve anchor for push-through installation.
• When the hexagon nut or screw is tightened, the cone is pulled into the expansion sleeve and expands tensioning it against the hole wall.
• A4 stainless steel version for outdoor use and in damp conditions (not part of the approval).
• FH II-SK is not available in stainless steel.

Advantages/Benefits

• The half-moon-shaped recesses stamped in the sleeve allows for contraction in length when tightened. This clamps the item being attached firmly against the concrete surface.
• Anchor versions for fixings with sophisticated design: FH II-S (hexagon head screw), FH II-H (cap nut) and FH II-SK (countersunk screw)
• All anchors can be removed flush with the surface.

Additional Information

• Anchor bolt for push        -through installation.
• When the hexagonal nut is tightened, the tapered bolt is pulled into the expansion clip and expands it against the drill hole wall.
• Version FAZ made is stainless steel A4 for outdoor applications and damp rooms. Highly corrosion-resistant steel (material number 1.4529) for application in aggresive atmospheres.
• FAZ-GS with large pre-assenbled washer for fixings in oblong holes.

Advantages/Benefits

• Optimised expansion clip ensures uniform load distribution for high permissible loads and small edge distances and axial spacings with structural elements, as well as secure expansion, even in cracked concrete.
• Installation-friendly, since only a few revolutions are necessary to apply the torque.